- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
- « Previous
- Next »
Re: Fan Control for the S10(e) - user-devel oped solution
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-09-2009 04:00 PM
with the NHC you can not control directly the fan...
i need onlye the program" S10Fan" for my S10-2
Re: Fan Control for the S10(e) - user-devel oped solution
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-06-2010 10:17 PM
Is there a way to shut the fan up when one is using windows 7?
Re: User-devel oped Fan Control for the S10(e)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
03-17-2010 01:45 PM
I've tried using S10fanctrl,
to see if it works, I set it to manual - off.
since then my fan does not work anymore, not even during bios post.
now it idles at 80c, and constantly shuts off due to over heat.
Lenovo S10
Model 20015
Bios version 14CN94WW
please advise
Re: User-devel oped Fan Control for the S10(e)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
03-17-2010 02:19 PM
That sounds similar to the battery detection problem. I would recommend to check if the problem can be solved with the same actions:
- remove AC-adapter and battery
- wait 30 seconds
- replace battery and AC-adapter
- test
- if it does not work, redo it with holding down the power button for 30 seconds.
Greetings
Carsten
Re: User-devel oped Fan Control for the S10(e)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
03-18-2010 12:43 AM
Thank you for your prompt reply. I was ready to go to the service center.
It took a few tries, but eventually the fan came back.
Tried playing with S10fanctrl again and everything works as advertised.
I use MobileMeter to monitor speedstep freq, temp and batt watt drain.
When S10fanctrl set to manual - off, MobileMeter always reports 35c.
When S10fanctrl set to manual - Lvl3, MobileMeter always reports 80c.
Just FYI.
- « Previous
- Next »
