03-17-2010 01:45 PM
I've tried using S10fanctrl,
to see if it works, I set it to manual - off.
since then my fan does not work anymore, not even during bios post.
now it idles at 80c, and constantly shuts off due to over heat.
Bios version 14CN94WW
03-17-2010 02:19 PM
That sounds similar to the battery detection problem. I would recommend to check if the problem can be solved with the same actions:
- remove AC-adapter and battery
- wait 30 seconds
- replace battery and AC-adapter
- if it does not work, redo it with holding down the power button for 30 seconds.
03-18-2010 12:43 AM
Thank you for your prompt reply. I was ready to go to the service center.
It took a few tries, but eventually the fan came back.
Tried playing with S10fanctrl again and everything works as advertised.
I use MobileMeter to monitor speedstep freq, temp and batt watt drain.
When S10fanctrl set to manual - off, MobileMeter always reports 35c.
When S10fanctrl set to manual - Lvl3, MobileMeter always reports 80c.
04-18-2011 06:38 AM - edited 04-19-2011 01:46 AM
Does this program works on S10-3c?
I measured core temperature with CoreTemp. When I boot netbook fan doesn't work. After loading windows 7 fan is working. Until 55 degre fan speed is normal but after 55 degrees fan speed is increasing and working loudly. I upgrade the BIOS version from 3CCN09WW to 3CCN13WW. But this is doesn't work. What can I do for solve this problem?
04-19-2011 01:56 PM
Hi and welcome,
No that program works only on older model. S10(e) . Newer model like S10-3 (& s / c / t) will not work different chipset and fan control register...