R60's Broadcom NetXtreme Gigabit Ethernet NIC doesn't work after standby/wake up in Vista [ Edited ]

[osenevp]

Hello.

I made a clean Vista installation from my recovery partion and installed new drivers for all controllers. But the NetXtreme Gigabit Ethernet NIC  is pain in the ass.I have to disable/enable it every time after R60 went out from sleep state to get LAN work. NetXtreme's  driver version is 10.39.0.0 which seems up-to-date. Any Idea?

P.S. Power managemet  WOL option - Wake up from a Magic Packet - is enabled. May be this is the case?

[osenevp]

When I unchecked the 'Wake up from a Magic Packet' option and checked 'Allow to turn off the device for saving power' NIC works with no problem after standby/wake up transitions.

Does anybody use WOL?

Before facory reset of Vista WOL function was OK.

[osenevp · Accepted solution]

It was my fault. Now I checked ALL check boxes in the Power Management tab  and setup WOL params in an Advanced tab (Wake on Magic Packet only checkbox). of NIC settings. Now everything is OK.