Support in other languages: 
Reply
Paper Tape
scampsmith
Posts: 2
Registered: ‎05-23-2011
Location: Michigan
0
Accepted Solution

How to clear the system-error LED

Hello,

 

Will clearing the Event/Error log in BIOS turn off the 'system-error' LED ? The server boots with a single-beep, and runs fine.

 

Thanks!

-- Stan Campsmith

Retired Employee
Serge1410
Posts: 2,438
Registered: ‎04-10-2011
Location: Malaysia
0

Re: How to clear the system-error LED

hi scampsmith,

could you provide to us the MTM of the unit so we could assist further ?





WW Social Media
Important Note: If you need help, post your question in the forum, and include your system type, model number and OS. Do not post your serial number.

Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"!



Follow @LenovoForums on Twitter!
Have you checked out the Community Knowledgebase yet?!
How to send a private message? --> Check out this article.
Paper Tape
scampsmith
Posts: 2
Registered: ‎05-23-2011
Location: Michigan
0

Re: How to clear the system-error LED

Its a RS110. The only entry in the Event/Error log is a warning about the RAM size changed (dating back to when the unit was built). The documentation is predictably lacking in practical, meaningful advice with regards to the system-error LED.

Thanks for the reply,
- Stan Campsmith
Lenovo Employee
jamesconner
Posts: 31
Registered: ‎04-17-2011
Location: RTP, North Carolina
0

Re: How to clear the system-error LED

This can be fixed by booting into BIOS and then press F10 to Save and Exit and you should not have this issue any further.

Lenovo Support Partner
Soundlab
Posts: 23
Registered: ‎08-20-2012
Location: Raleigh, NC
0

Re: How to clear the system-error LED

I second Mr. Connor.  That noise is hard to bear if you can't shut it off!  LOL.