cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
PTI
Paper Tape
Posts: 3
Registered: ‎06-26-2019
Location: CL
Views: 211
Message 1 of 5

FIRMWARE CMM

Goodnight the GUI (CMM) shows san switch in yellow, however it works well, has this happened to you?

Lenovo Employee Dannyhsueh
Lenovo Employee
Posts: 166
Registered: ‎08-05-2018
Location: US
Views: 186
Message 2 of 5

Re: FIRMWARE CMM

Hi Sir,

 

The Chassis Graphical View contains an interactive graphic of the front and rear view of the chassis. Each component shows a colorcoded overall status to indicate any problems that might exist for that device, with green indicating normal operation, yellow indicating that a non-critical event has occurred, and red indicating that a critical event has occurred. 

  • Green Normal - All monitored parameters in the chassis are within normal their operating ranges.
  • Yellow Warning - There are currently active warnings or system events, but no critical events are active.
  • Red Critical - One or more critical events are currently active.

You can refer CMM user guide section Event log options to collect event log and filter event notifications by selecting warning events only to get system information in detail.

Lenovo Employee JVOSS2
Lenovo Employee
Posts: 276
Registered: ‎07-17-2018
Location: US
Views: 132
Message 3 of 5

Re: FIRMWARE CMM

PTI,

 

Checking in to see if the information Dannyhsueh provided what what you were looking for. If not, please let us know and we can move forward with resolving this post.

 

If everything is looking good please select a solution for this post so others can use it if needed.

PTI
Paper Tape
Posts: 3
Registered: ‎06-26-2019
Location: CL
Views: 80
Message 4 of 5

Re: FIRMWARE CMM

very good afternoon team, very valuable information from Dannyhsueh Your help and recommendations. to start the update of the CMM's which is the recommendation first update the PRYMARY OR STANDBYE ???

 

Highlighted
Lenovo Employee Dannyhsueh
Lenovo Employee
Posts: 166
Registered: ‎08-05-2018
Location: US
Views: 63
Message 5 of 5

Re: FIRMWARE CMM

Please refer the link for detail information about CMM firmware update. 

If your Flex System Enterprise Chassis is configured for redundant operation and a second CMM is installed, both will have the same level of firmware after the primary CMM updates the standby CMM after it is installed.

Check out current deals!


Shop current deals

Top Kudoed Posts