Welcome to our peer-to-peer forums, where owners help owners. Need help now? Visit eSupport here.

English Community

Datacenter Networking

Events

Featured

See Full Board List

Title
VIEWS
POSTS
LAST POSTS
1058
4
by mslavin-new
2021-04-02, 12:39 PM
481
2
by mslavin-new
2021-03-30, 2:13 AM
725
3
by ARK22
2021-03-30, 9:59 AM
2317
6
by JVOSS2
2021-03-10, 19:29 PM
1333
5
by northbear
2021-03-07, 10:55 AM
967
4
by Abdelbasset
2021-02-08, 21:00 PM
1043
5
by headache
2021-01-20, 18:06 PM
1066
7
by headache
2021-01-25, 15:24 PM
985
2
by mslavin-new
2021-01-18, 18:47 PM
1239
11
by JVOSS2
2021-01-11, 16:42 PM
1259
4
by ca74
2020-12-24, 4:29 AM
1476
6
by JVOSS2
2020-12-08, 15:55 PM
1402
7
by inkubu
2020-12-01, 16:24 PM
1876
12
by annasamuel
2021-02-20, 15:04 PM
1332
2
by mslavin-new
2020-11-05, 19:21 PM
1616
5
by arpderp
2020-10-27, 8:17 AM
1653
2
by arpderp
2020-11-14, 14:51 PM
1502
4
by JVOSS2
2020-10-30, 20:25 PM
1558
12
by Rouqueiro
2020-10-06, 11:02 AM
1506
5
by Lenodo
2020-09-21, 10:27 AM
1448
4
by JVOSS2
2020-09-16, 12:35 PM
1435
3
by HarisKr
2020-09-10, 17:40 PM
1575
12
by tjgray
2020-09-17, 17:21 PM
1724
6
by mslavin-new
2020-08-21, 14:14 PM
2056
11
by tpapanin
2020-10-27, 3:46 AM
1586
3
by mslavin-new
2020-08-12, 14:32 PM
2000
13
by mslavin-new
2020-09-30, 17:26 PM
1815
6
by mslavin-new
2020-07-24, 15:42 PM
1627
3
by Nate-DFG
2020-07-23, 16:14 PM
1999
9
by mslavin-new
2020-07-31, 12:46 PM
TITLE
Content
Author
Hello Martin,   While using VRRP in such a fashion (4 nodes) is supported, I have only ever seen it done in a lab to show as an...
by mslavin-new
2021-04-02, 12:39 PM
Thanks for your reply Matt. You´re right, keep it simply is most of the time a good principle.   Leaving the HP out of sco...
by Max3108
2021-04-02, 10:56 AM
Hello,   Just my opinion, but I have found that creating complex network environments usually does not go well in the long run....
by mslavin-new
2021-04-02, 0:58 AM
Hi,   currently we still have two HP 5406 switches as core running VRRP in a master/backup configuration for various subnets/vla...
by Max3108
2021-04-01, 14:03 PM
Thank you very much for detailed explanation Matt.   We are using following Cisco IOS Software, s2t54 Software (s2t54-ADVIPSERV...
by ARK22
2021-03-30, 9:59 AM
Hello,   I believe one of the odd things about management ACLs in CNOS is that there is no implicit "deny all" at the end of the...
by mslavin-new
2021-03-30, 2:13 AM
Hi All, I have a NE1032 running CNOS 10.10.2.0 and configured for SNMP, the SNMP is Woking fine. Currently SNMP is available on any v...
by CallumR
2021-03-30, 1:06 AM
Hello,   The whole point of vLAG is to let you make a single aggregation that is split across two separate switches (Flex bay 1...
by mslavin-new
2021-03-29, 16:59 PM
Hi,   I'm in process of configuring 2*EN4093R switches in flex chassis to our Core Cisco VSS switches.   EXT1 to EXT8...
by ARK22
2021-03-29, 16:15 PM
DoMaZiO,   I just sent you a reply to your-email. Wanted to inform the thread that this is still being looked at.
by JVOSS2
2021-03-10, 19:29 PM
I will send you a PM with my e-mail address.
by JVOSS2
2021-03-07, 18:48 PM
Hi, JVOSS2 Is there any updates? 
by northbear
2021-03-07, 10:55 AM
For the tech-support data, I prefer to send you privately: how could I do ?
by DoMaZiO
2021-03-06, 10:57 AM
Hi,   attached the network topology.   In brief: ENDPOINT 1 reach devices connected to SD-WAN VRRP, ENDPOINT 2 do not...
by DoMaZiO
2021-03-06, 10:54 AM
Hello DoMaZiO,   Welcome to the community!   Would it be possible to provide some information from the switches (show...
by JVOSS2
2021-03-05, 20:55 PM
Dear all,   we have 4 Lenovo NE1032T configured as 2 vLAG peers in 2 tier ID.   In every switch there is a VRRP confi...
by DoMaZiO
2021-03-05, 9:24 AM
I suppose it would be ok provide the list here. It was generated by command:  snmpwalk -M mibs/:mibs/enterprise:common-mibs/:/usr/sha...
by northbear
2021-03-03, 6:51 AM
Thanks... NP, I can provide list of oids by email but without values because of security reasons. As I said all this oids are from modules...
by northbear
2021-03-03, 6:26 AM
Hello northbear,   Welcome to the community!   Would you mind sharing the output you are getting? If not in the forum...
by JVOSS2
2021-03-03, 0:13 AM
Hi, guys We have several switches NE1032T with CNOS 10.9.1.0. I'm configuring monitoring of the switches via SNMP v3 and noticed that the...
by northbear
2021-03-02, 23:49 PM
Software Version 8.4.19
by JCIBMBGIS
2021-02-22, 18:19 PM
Hello, can you share the version of code in use on the switch? The procedure is different on different versions of code.   Thank...
by mslavin-new
2021-02-22, 17:29 PM
Hi, using a 4093r, please send me the code to enable 3rd party optics. Need to test a few different optics, specifically Cisco 10G SR OE...
by JCIBMBGIS
2021-02-22, 16:38 PM
Many computers have a button at the side of the CPU or at the left side of laptop. If that button is pushed down, system does not catch wif...
by annasamuel
2021-02-20, 15:04 PM
PM received, thank you!   damian 
by Dbflying
2021-02-17, 19:17 PM
We are running into the same issue on our NE1032.   System version 10.9.1.0   Any help would be greatly appreciated.
by spearmint
2021-02-17, 17:07 PM
PM sent for the above requests.   Thanks, Matt
by mslavin-new
2021-02-17, 16:23 PM
Hi Matt,   I would also appreciate the xcvr unlock command for a G8316.  I am troubleshooting it in a non-production enviro...
by Dbflying
2021-02-17, 16:15 PM
Hey! I have a RackSwitch G8264 in the lab and I need the command to enable unapproved tranceivers aswell..   #show interface tra...
by pasikfs
2021-02-15, 11:03 AM
Hi Matt,   Can you send me the command for enabling the unapproved tranciever on RackSwitch EN1032?   Software: &n...
by kgerie
2021-02-09, 13:53 PM

Community Guidelines

Please review our Guidelines before posting.

Learn More

Check out current deals!

Go Shop