cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
satwalker
Paper Tape
Posts: 6
Registered: ‎11-24-2015
Location: Buitenpost
Views: 1,254
Message 11 of 20

Re: Storcenter Pro 150d Recovery Media

Nothing else happens.... the indicator Lamp of the Stick shows me some action at the Start but then nothing happens and the 3xred and 3xgreen at the status Lamp of the Storcenter does appear!

If the USB Stick stops blinking this is no reason that the iomega is finnished the programming. Wait 10 to 15 minutes.
After finishing the programming, the NAS should shut down automaticly.
Disconnect the USB and reboot the NAS and look for the IP so you can connect to the webinterface.

The leds of the disks are totaly colored blue?
Try the method i wrote late in this topic)
satwalker
Paper Tape
Posts: 6
Registered: ‎11-24-2015
Location: Buitenpost
Views: 1,253
Message 12 of 20

Re: Storcenter Pro 150d Recovery Media

Maybe the disks you are using are not compatible?
The iomega creates a boot partition an the DISK )
Soucoma
Fanfold Paper
Posts: 11
Registered: ‎12-10-2015
Location: what?
Views: 1,242
Message 13 of 20

Re: Storcenter Pro 150d Recovery Media

Until now it happen some things:

I do anything you explained...
but its always the same... blinking 3xred/3xgreen for hours....
I put only one disk in it and all what is happend that the disk is partitioned in 2 primary partitions 1: 3,92 GB and 2: the rest of the disk....
But the Storcenter never turns of... it runs forever in the State redgreen....
I see the IP of the Storcenter but can´t reach the Webinterface....
The Diskindikator Lamp is always blue and not flickering.... it stays blue for all the time!

I will try something other (make a dynamic disk, change MBR to GPT...

The Storcenter itself seems running right....
As i can see the Partitioned Disk may also right handled...
I can see the given IP from DHCP Server... seems OK....

But the CD Rom doesnt really do something.... (its Connected to one of the Ports at the Backside from the Storcenter.
At startup phase it runs shortly then spin down and no opperation....

Hm... now i try it with the GPT Disk....
The Status Lamp of the Storcenter stays Red for 5 Mins....
Thats different from the other Times i tried....
I will wait now for 15 - 30 Mins befor i try something different!

By the Way: Do you understand what i am writing here?
My english is surely horrible, i am really soory for that!
satwalker
Paper Tape
Posts: 6
Registered: ‎11-24-2015
Location: Buitenpost
Views: 1,238
Message 14 of 20

Re: Storcenter Pro 150d Recovery Media

You do it the right way

 

I don't understand why is is not working in youir case.

 

If you have four disks, try it with 4 harddisks in the enclosure

In my case it was working with this image and 4 harddrives

 

And are the disks the same volume capaticity

I think this is important

 

Let me know

 

Kind regards,

 

Menkes

 

 

 

Soucoma
Fanfold Paper
Posts: 11
Registered: ‎12-10-2015
Location: what?
Views: 1,234
Message 15 of 20

Re: Storcenter Pro 150d Recovery Media

Now after some "not response kill it with the backside switch"...
The Network indicator LEDs not blinking any more oO
Did i kill the Storcenter?
I have no reaction any more.... Turn on Maschine ending with: Red Light Status Lamp and Blue HDD Lamp, both permanent!
Before i had flickering LAN LEDs!
Now, nothing! Smiley Sad
Soucoma
Fanfold Paper
Posts: 11
Registered: ‎12-10-2015
Location: what?
Views: 1,226
Message 16 of 20

Re: Storcenter Pro 150d Recovery Media

Hello again, its Update time!

I dont know how, but it seems that i killed the Ram inside the Box!

It was a simple 256MB DDR Ram in it, so i installed something i got flying around here a 512MB with a little bit more MHZ (dont know how much exactly!)

So it turns on and i got some flickering LEDs now... again... 3xRed/3xGreen.... this means (Manual) HDD error or something like that, but its logical because i have no HDD with the Webapplication on it or the Storcenter OS or Name it like you want....

What i dont understand is, the CD Rom (CD USB DRIVE) i connected to the Back is doing something.... at startup it spins up.... then go down... for initializing Harddisks i think.... then after it goes to 3xred/3xgreen status it spins up again.... then go down for some reason (in this moment the Back Sided Fan starts his Job) after this the CD Drive spins up and stay at mid to high rpms.... BUT without reading prozess from the Disk (working LED from CD Drive stays dark) Disk Spin Stand By to read imediatly ... (Dear Santa i wish me a Dictionary for Chrismas thanks...) oO

 

What i think what´s may be possible is that the HDD dont have the Right partion Table* (now i try the mac Partitioning Table, because the Storcenter is maybe a Power PC architecture so this would be make sence)

But it seems that this dont change anything....

 

*With the wrong Partition Table the CD is starting but waiting for a properly Disk to write to them?!?!

Soucoma
Fanfold Paper
Posts: 11
Registered: ‎12-10-2015
Location: what?
Views: 1,222
Message 17 of 20

Re: Storcenter Pro 150d Recovery Media

Okay... hm.... i tried somthing new...
I blanked the Disk (the Harddisk) and put it into the Storcenter wich connected to the USB CD Drive....
I started it up and wait a few..... 30 Minutes....
So then i turned it off and pull out the Disk from the Array....
I put the Disk into my Win7 Maschine and start the Admin Acc. to go into Partition Tool/ Harddisk Manager
Then i see (again) that there are 2 Partitions on the Disk (1. 3,92GB second the rest of the Disk)
But not have a Filesystem yet... ( in Linux i can see that the First 3,92 GB Partition should have Fat32 (what i should see in Win7 too))....
So i formated the first Partition with Fat32 and the second with exfat.....

Now its so that i have some Reading Progress at Startup Phase (of the Storcenter) and i will wait for something to happen....
Soucoma
Fanfold Paper
Posts: 11
Registered: ‎12-10-2015
Location: what?
Views: 1,221
Message 18 of 20

Re: Storcenter Pro 150d Recovery Media

Oh sorry, i mean Reading Progress of the USB CD ROM Drive connected to the Storcenter (i hope you can follow me to this point)
Enigmapc
What's DOS?
Posts: 1
Registered: ‎06-19-2017
Location: GB
Views: 542
Message 19 of 20

Re: Storcenter Pro 150d Recovery Media

Hi

 

Any chance any one can let me have a copy of the Recue CD via iso or an upload?

 

Thanks

Highlighted
np17
Paper Tape
Posts: 2
Registered: ‎11-08-2018
Location: IT
Views: 31
Message 20 of 20

Re: Storcenter Pro 150d Recovery Media

Hi
can I have iso with 85.85 firmware?
Thanks, bye np17

Holiday Deals
HAPPENING NOW!

Get the best deals on PCs and tech now during the Holiday Sale
Shop the sale

Top Kudoed Authors