12-08-2011 04:00 PM
I am having problems with my DVD drive in my A700 machine. The drive is a Sony Optiarc DVD RW AD-7640S. When I put in in a disk I hear the drive spin but when I click to open the drive in My Computer it prompts to insert a disk and ejects the one in there, sometimes it will show two drives one as DVD and one as CD. I have tried many different types of disks as well as using the Lenovo Toolbox, which also asks me to insert a disk. I have removed the DVD drive in the device manager and reinstalled, the driver is listed as being Microsoft and up-to-date.
I have not been able to locate a different driver for this device even off of Sony's website the product is not listed. I considered a possibilty of a bad lens and wanted to replace the drive but notice that there is a seperate eject button in the casing of my machine, powered from the board. This DVD drive has the eject button to the far right and most that I am finding are off-center. Has anyone experienced this issue and believe it to be a driver problem and know where to get a driver? Or if I need to replace the drive can I use any notebook SATA drive or does it have to be this model because of the button in the casing?
Any suggestions are appreciated!
12-09-2011 12:02 AM - edited 12-09-2011 12:07 AM
welcome to the forums.
i do find it weird that in My Computer it shows two optical drives when clearly you only have one and thus i would like you to get into device manager and uninstall the current driver for the DVD drive.
this should then prompt windows to install generic drivers, let it do so.
if this does not work, head over to http://consumersupport.lenovo.com/us/en/DriversDow
check your system and if there is anything out of date; update it.
12-09-2011 06:49 AM
Thank you for the advice. I have tried on uninstalling the driver and reinstalling previously, but I did try it again. I reinstalled the generic driver and the drive still did not work. I have checked the updated drivers from Lenovo but I do not see one available for the DVD drive. I have also tried searching the internet for a driver with no luck. I think I am at the point where I will just try replacing the drive. Can I only use the same drive brand and model because of the eject button on the side panel molding or will any drive work?
12-19-2011 06:34 PM - edited 12-19-2011 06:35 PM
any brand should work.
though i would recommend bringing the whole unit and test it out there.