10-27-2017 04:08 AM
i have forget my Masterpassword for Bios. Adminpasswort works. I can also go to Bios but not to all Defaults.
Can i reset all Passwort for Bios ?
10-27-2017 06:14 AM
..... this post was moved to its own thread in the correct forum.
10-27-2017 06:42 AM
Welcome to the Community Forums.
You must remember the password or at least try to.
Refer to your computer hardware manual about passwords from support.lenovo.com.
"Attention: If the SVP has been forgotten and cannot be made available to the servicer, there is no service procedure to reset the password. The system board must be replaced for a scheduled fee."
As many as three passwords may be needed for any Lenovo computer: the power-on password (POP), the hard disk password (HDP), and the supervisor password (SVP). If any of these passwords has been set, a prompt for it appears on the screen whenever the computer is turned on. The computer does not start until the password is entered.
Exception: If only an SVP is installed, the password prompt does not appear
when the operating system is booted.
A power-on password (POP) protects the system from being powered on by an unauthorized person. The password must be entered before an operating system can be booted.
There are two hard-disk passwords (HDPs):+ User HDP - for the user + Master HDP - for the system administrator, who can use it to get access to the hard disk drive even if the user has changed the user HDP
Attention: If the user HDP has been forgotten, check whether a master HDP has been set. If it has, it can be used for access to the hard disk drive. If no master HDP is available, neither Lenovo nor Lenovo authorized service technicians
provide any services to reset either the user or the master HDP, or to recover data from the hard disk drive. The hard disk drive can be replaced for a scheduled fee.
A supervisor password (SVP) protects the system information stored in the BIOS Setup Utility. The user must enter the SVP in order to get access to the BIOS Setup Utility and change the system configuration.
Hope this answered your query.