cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
TB689
Paper Tape
Posts: 2
Registered: ‎03-14-2018
Location: GB
Views: 1,205
Message 1 of 4

Replacing v110-15isk (80TL) keyboard

I'm having to replace the keyboard on a V110-15ISK laptop . However the keyboard and its aluminium cover plate have no screws that can be removed, but seem to be 'welded' to the front cover of the laptop,  using pre-moulded plastic pillars.

 

Has anyone had to replace one of these keyboards or has any suggestions ??

 

thanks

 

Sr Support Specialist
Posts: 8,536
Registered: ‎11-30-2015
Location: PH
Views: 1,174
Message 2 of 4

Re: Replacing v110-15isk (80TL) keyboard

Hi TB689,

 

Welcome to the Community Forums.

 

Checking from the hardware manual, the keyboard are bundled with the upper case. Replacement of the keyboard may require the entire upper case removed.

 

You can reference the upper case removal here in page 54 along with the service module for reference.

 

Hope this helps answer your query.

 

Regards



Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.

TB689
Paper Tape
Posts: 2
Registered: ‎03-14-2018
Location: GB
Views: 1,164
Message 3 of 4

Re: Replacing v110-15isk (80TL) keyboard

Thanks for the reply Spidey101,

No problem with stripping the laptop down, however the manuals seem to suggest that I need to buy a complete upper case (with keyboard pre-fitted ).
After a bit of soul searching I have decide to carefully remove the tops of all the plastic 'welds' with a sharp knife, from both the aluminium cover and keyboard.
Then replace the keyboard with the new one and then use a touch of 'hot glue' dabbed on the top of the plastic pillars to 'weld' it back into position.
Will post the result on how it goes!
Sr Support Specialist
Posts: 8,536
Registered: ‎11-30-2015
Location: PH
Views: 1,161
Message 4 of 4

Re: Replacing v110-15isk (80TL) keyboard

Hi TB689,

 

This was the same DIY steps other techs do as seen in some videos  for  glued keyboards in the upper case.

Similar projects do work out ok with the right materials and not rushing on the glued parts. 

 

I am optimistic that all would go well.

 

Regards



Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.

Check out current deals!


Shop current deals

Top Kudoed Authors