08-01-2016 12:46 PM
I purchased a yoga 2 13 pro and the mobo went bad. After being told by support that the mobo is no longer available, I replaced it with the exact motherboard I found on ebay. Upgraded it to Windows 10 and upgraded the bios. The bios stated "Get EC part information fail". Did a product detection. It stated it was a yoga 2 pro.
What caused me to investigate is that the sensors for rotation are not rotating the screen properly.
Is there anyway to fix this?
08-01-2016 02:51 PM
Hi geekmarine ,
Welcome to the Community Forums.
Verify that your system board was intended for Yoga 2 Pro for your BIOS update as it would be different from a Yoga 13 , not using the SN but instead type the name directly. This would allow us to proceed from the message we encountered similar to this discussion.
With the auto rotation , once BIOS and system drivers are properly installed as the rotation board cables are in place to follow suggested steps in this post.
Update us how it goes.