cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
Highlighted
Dan312
Fanfold Paper
Posts: 5
Registered: ‎12-01-2019
Location: RU
Views: 246
Message 1 of 6

px2-300d reset login/password

Good day!

Forgot login / password. According to the instruction: hold the reset button for four seconds to reset the security and network settings. This allows you to restore access if the network settings are incorrect or you forget your password.

But the instructions do not specify the default login password?

Tried admin, blank is not suitable.

 

Dan312
Fanfold Paper
Posts: 5
Registered: ‎12-01-2019
Location: RU
Views: 194
Message 2 of 6

Re: px2-300d reset login/password

Please. Does anyone know the default login / password?

Lenovo Employee Dannyhsueh
Lenovo Employee
Posts: 300
Registered: ‎08-05-2018
Location: US
Views: 180
Message 3 of 6

Re: px2-300d reset login/password

Hi Sir,

 

There is no default login / password. After perform a full factory reset, it require a user to set up an admin account.

Dan312
Fanfold Paper
Posts: 5
Registered: ‎12-01-2019
Location: RU
Views: 169
Message 4 of 6

Re: px2-300d reset login/password

Thanks, I did.

Lenovo Staff
Lenovo Staff
Posts: 393
Registered: ‎08-14-2018
Location: US
Views: 151
Message 5 of 6

Re: px2-300d reset login/password

Hello Dan, it sounds like you were able to get in now? If that is the case could you mark this as resolved so others can find the answer? 

Dan312
Fanfold Paper
Posts: 5
Registered: ‎12-01-2019
Location: RU
Views: 117
Message 6 of 6

Re: px2-300d reset login/password

Hello!

Unfortunately, the user manual is incorrect information.

Decision:

Follow the instructions below to use the reset button.
 

  1. Power on your network storage device and wait until it completes the startup sequence. (All front panel LEDs will stop blinking once startup completes.)
  2. Press and hold the reset button for about 15 (untill 30) seconds until the front panel power button begins blinking.

NOTE: On most ix and px network storage devices, the reset button is located on the back panel. For the px4-300r, the reset button is located on the front panel. If you are unable to locate the reset button, refer to the section "About... Components" in the User's Manual (User Guide) for your device.

  1. The device will restart automatically. Wait until system restart completes.
  2. Once restart completes, you can use the Storage Manager client software to discover the device, or you can manually connect to the web management interface by entering the model name in the web browser on your client computer.

Re-enable security and adjust network configuration settings as needed.

Check out current deals!


Shop current deals

Top Kudoed Authors