Showing results for 
Search instead for 
Did you mean: 
Fanfold Paper
Posts: 8
Registered: ‎07-11-2014
Location: Kiev
Views: 2,355
Message 1 of 4

px4-300r Recovery Mode

Good afternoon.

Booting store px4-300r. Loading indicator flashes 2-3 times per second. LAN access is not. Terminal connected to a COM port (post below)
1. Where to Load BIOS File?
2. After recovery via Recovery Mode will remain whether the device settings and data on your disks?

Thank you.


<PEI>Smiley Tonguelatform Powering On.
<PEI>Smiley Frustratedtart to Do Memory Initialization and ECC Scrubbing...
<PEI>:Memory Initialization and ECC Scrubbing Success.
<PEI>:Go to DXE phase to do initialization...
<PEI>Smiley Tonguelatform Enter Recovery Mode.
<PEI>:Try to Load BIOS File from USB Device...
<PEISmiley MadIt will take maybe 2 min, do not remove USB Disk)
<PEI>Smiley Tonguelease Plug a Recovery USB, Then Reset System.

Retired Support Specialist
Posts: 545
Registered: ‎06-23-2014
Location: Orem Utah
Views: 2,297
Message 2 of 4

Re: px4-300r Recovery Mode

Do you know what changed that may be causing this? Does the power light go solid?


Have you tried a drive isolation by removing one disk at a time and see if you can access it? If that does not work you may want to call support and get the imager software if you under warranty.

Fanfold Paper
Posts: 8
Registered: ‎07-11-2014
Location: Kiev
Views: 2,274
Message 3 of 4

Re: px4-300r Recovery Mode

The device is not a guarantee.
While in Ukraine could not find service center who wanted to fix a this network storage.

What are some other ideas?

Paper Tape
Posts: 2
Registered: ‎07-10-2019
Location: US
Views: 207
Message 4 of 4

Re: px4-300r Recovery Mode

Just asking, how can I get into Recovery mode???



Check out current deals!

Shop current deals

Top Kudoed Posts