cancel
Showing results for 
Search instead for 
Did you mean: 
Retired Moderator
Views: 1,071

Question

I tried to use the available marvell controller from the support site to configure the SAS in my D20.It doesnt work out.How do i solve this issue?

Answer

Make sure you are running the kernel with version number 2.6.31-1 and above.Also  make it to boot normally to install GRUB on a disk connected to an AHCI port for optical drives (sdb) while the whole system is installed on a disk connected to a Marvell port (sda)

Was this information helpful?

Contributors