cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
KrowBar
Punch Card
Posts: 12
Registered: ‎06-28-2016
Location: US
Views: 431
Message 1 of 3

Accessing SN550 pureflex node from CMM goes ditrectly to remote console.

Hello,

 

when "launching" the remote console of a SN550 pureflex node (tpye 7X16) from CMM2 the page goes ditrectly to remote console. actually it's indirectly, as I can "back buton" to the BMC.

is there a configuration option (or anything) to cease the automatic jump through to the remote console?  a way to only go directly to (and stay at) the BMC?

 

-KrowBar

Lenovo Employee danielwang_SZ
Lenovo Employee
Posts: 84
Registered: ‎08-23-2016
Location: CN
Views: 205
Message 2 of 3

Re: Accessing SN550 pureflex node from CMM goes ditrectly to remote console.

Yes, there are two options, one is remote presense (directly go to remote console) and another is main page(directly to XCC page). You can find them in the dropbox of " context" on the "launch node console " page after clicking the "launch compute node console" for each node.
Highlighted
KrowBar
Punch Card
Posts: 12
Registered: ‎06-28-2016
Location: US
Views: 180
Message 3 of 3

Re: Accessing SN550 pureflex node from CMM goes ditrectly to remote console.

that's the solution.... right there under my mouse:

bmc.access.option.jpg

 

Check out current deals!


Shop current deals