09-20-2016 05:18 AM
I am working on setting up the T410s I got recently.
When I start the Test, then it skippes, or shows a scratched symbol for the NVS 3100M GPU RAM Test, saying it's not needed.
When I open the Protocol, it says following on Position:
PCI bus 1, device 0, function 0
Does this mean, the card is actually not running?
Also, I got some Keyboard buttons that wont work: (^,q,a,y)
I might need to check the Bios, to see if the card is active. It does show the card in the device manager though.
Thx for help and opinions!
09-20-2016 07:09 AM
So, I read that the extra GPU is used additionally via the Lenovo Power Management. I checked the Bios and it is set to "switchable". And the Power management should activate the NVS GPU depending on needed or not.
I might have to try to switch to "discrete" and see the difference.
There is 4k Video footage on the Laptop and it's not running smoothly. I thought with the NVS it would run.
Also, I replaced the Keyboard. And the other one is working fine. So maybe there is a crack in the wire..