08-29-2011 04:54 PM
My x220 has a similar problem. It looks like the two parts are glued together in just a few points so there are tiny gaps. The corners of the lid suffer the most and are very squeaky. I tried taping the corners and then it was all good, except it looked ugly. Is there a way to fix this? Squeaking is very annoying.
08-29-2011 09:29 PM
08-30-2011 12:29 AM - edited 08-30-2011 12:29 AM
The only idea I have to fix the problem is to burn the plastic a bit so that it melts and secures the two parts in contact. I hope this is not the best idea.
Anything else I could do?
Would it be possible to put glue in the holes somehow, with a needle?
08-30-2011 02:39 AM
08-30-2011 02:56 AM
Really? I heard they don't fix squeaking as it has nothing to do with functionality of the laptop. And it really doesn't, especially if it is just a corner of the lid.
08-30-2011 03:08 AM - edited 08-30-2011 03:09 AM
if it just squeaking they probably wouldn't attempt to fix it. But if has an ill fitted frame, then they would probably oblige to fix it.
I mean if you are adamant to try melting the plastic as a way to fix this issue, then you could but i would imagine you won't get much success (and my friend also tried it once on a T43 and the result was probably not one would expect, it softened the plastic but it didn't melt it enough to make it stick to the magnesium frame).
If you are going to use a heat gun on the X220 you would probably cause the LCD polarising film to melt.
08-30-2011 05:27 PM