11-13-2013 01:20 PM
I recently did a clean install of Windows 8.1 on my X230T, and also installed Office 2013.
I need to use the digitizer with OneNote 2013 heavily for taking lecture notes.
As I did when I was using Windows7, I set the side button on the digitizer to "eraser" and expect that it works properly.
However, it is not the case.
Yes I can write with the tip without any problem.
Unfortunately, when I tried to press the button to switch the tip from the pen mode to the eraser mode, the behavior
of the digitizer becomes pretty strange.
(1) If I remain the tip close to the screen, it would not switch to the eraser mode
(2) if I move the tip a little higher and let the cursor disappear, then hold the button and move the tip back to the screen, I SOMETIMES get the eraser mode; but it doesn't switch back to the pen mode even if I release the button.
I need to again move the tip far away from the screen and release the button to get the pen mode back.
I downloaded the up-to-date driver from Wacom but it doesn't help.
Also, I cannot find the driver for this functionality for Windows 8.1 on Lenovo website;
the latest version of multitouch driver only supports Windows 7 and older versions of windows.
Does anyone experience the same problem as I did?
Can somebody help?
Thanks a lot!
Solved! Go to Solution.
11-14-2013 06:20 PM
Have a look at this thread (last message): http://forums.lenovo.com/t5/X-Series-Tablet-ThinkPad-Laptops/Inking-in-onenote-x220t/m-p/1281619#M24...
Solution: OneNote 2013 is buggy. Version 2010 works fine.