04-11-2011 07:04 AM
a newly deployed TD230 (1029-12G) entertains us with an undocumented beep sequence. The sequence is as follows:
Two short, two long and a strange "double-beep".
POST takes about 1 minute and shows no errors. During POST the LEDs "diagnostic", "status" and "system ID" flash for a few moments. Afterwards only the 5VSB LED is on. Entering setup or ESRT2 is sluggish.
I checked the cabling several times and made sure the single 4GB RAM module is socketed tightly. Of course the board is deployed with only one Xeon E5507 CPU. The system is also equipped with 4 x 1TB Hitachi HDs (provided by Lenovo).
A system diagnostic CD (grml 2010.12) took unusually long to boot but behaved well once booted and did not find any errors.
Furthermore, the system announces three MACs, but only two are documented on the hardware.
Does any of you have information with regards to the undocumented beep sequence and/or the third MAC?
04-12-2011 01:25 AM
some more information. I reset the BIOS (again) and everything stays the same, but the system now only reports two MACs.
Also, we are coming to the point where replacement is cheaper than trouble-shooting. I guess, the machine will be returned and replaced.