Welcome to our peer-to-peer forums, where owners help owners. Need help now? Visit eSupport here.

English Community

ThinkStationThinkStation Workstations Knowledge Base

SAS cable for ThinkStation D10, D20, and C20x using on-board SAS controller

Question

What cable do I need to use SAS drives in my ThinkStation D10, D20, or C20x?

Answer

If you have a ThinkStation D10, D20, or C20x with an on-board LSI (D10) or Marvell (D20 and C20x) SAS controller, you will need cable FRU 41R5513 to correctly connect your SAS drives to the sockets on the system planar (aka "motherboard").

 

FRU 41R5513 (45cm / 18" long)

1D3X4125.jpg

 

The planar socket end is a typical SATA connector with locking tab.  The drive end is a SAS 29 connector (pictured below).

1D3X4121.jpg

 

The SAS 29 connector end is compatible with both SAS and SATA hard disk drives.

Was this information helpful?

Yes No

Comments

Community Guidelines

Please review our Guidelines before posting.

Learn More

Check out current deals!

Go Shop
X

Delete