09-14-2009 08:34 PM - edited 09-14-2009 08:38 PM
I've got a 15" 3000 n100 with the adi/soundmax sound card. I noticed right away after installing windows 7 that the sound card goes into a power save mode after a few minutes and when it comes out of it, the speakers click the first time it tries to play a sound. very annoying. does the same thing in vista, but in vista you actually get a soundmax control panel where you can disable the power save mode. no such luck in win7, at least not until they get around to releasing a proper driver for it.
Obviously, such an affront cannot be tolerated, so change these three registry settings and reboot to disable it.
Make sure that device 0000 is the soundmax card; it'll tell you in the main 0000 key.
03-29-2012 08:12 AM
I signed up just to thank you too
Different PC, different MoBo (Asus P5VD2-VM) , but it has a SoundMax internal soundcard.
I couldn't find a driver for Win7, so had to use a Vista one (64-bit) from Asus.
This suffered from power up/down clicks and as you said, I didn't get a control panel.
Changed registry, rebooted, and problem resolved.
04-18-2012 02:22 AM
Just have the same problem with the annoying sound bips.
When i tried to change the registry i saw that ConservationIdletime, Performance Idle Time and Idlepowerstate already had the 00 00 00 00 Value.
I just added the PM_EAPD_Mode value. But strangely, nothing changed after reboot.
Can anyone help?
05-29-2012 08:26 AM
Another person signing up to say thanks. On my HP Compaq nx7400 (Ghawd, it sounds silly to say "HP Compaq", but that's what they're technically called.) this setting (I'm assuming) was changed after a driver update. The problem is a bit more sinister than simply an audible click. After the chip had been turned off, it got stuck in a "mute" state, even after resuming sound playback. To get out of this state, I needed to open the volume mixer and manually mute/unmute, or adjust the volume. However, up doing so, the Windows mixer application would hang for a couple of seconds, presumably while the driver was restarted. This was using the official Vista/7 sound driver from HP's homepage.
All this while experimenting woth trying to get stereo mix recording to work. Since I'm here, here's the answer for that. In the sound control panel, recording tab, right click the list box and choose show disabled devices. If you just enable the stereo mix device, it's "currently unavailable". No good. Disable the other devices, (or set stereo mix as the default) and now the stereo mix device should be woking. Turns out the sound chip only has one input, which is multiplexed to the input devices.
10-06-2017 12:12 PM
thank God for that. works otherwise
Windows 10 ., HP Pavilion 15-bc015nt ., Realtek ALC295 / HDAUDIO
ConservationIdleTime 1 e , 00 , 00 , 00
IdlePowerState 03 , 00 , 00 , 00
PerformanceIdleTime 00 , 00 , 00 , 00